location (interface configuration)
location (interface configuration)
Use the location interface command to enter location information for an interface. Use the no form of
this command to remove the interface location information.
Syntax Description
additional-location-information
civic-location-id
elin-location-id
id
word
Defaults
This command has no default setting.
Command Modes
Interface configuration
Command History
Release
12.2(40)SE
Usage Guidelines
After entering the location civic-location-id id interface configuration command, you enter civic
location configuration mode. In this mode, you can enter the additional location information.
Examples
These examples show how to enter civic location information for an interface:
Switch(config-if)# int g1/0/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
Switch(config-if)# int g2/0/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
You can verify your settings by entering the show location civic interface privileged EXEC command.
Catalyst 2960 Switch Command Reference
2-170
location {additional-location-information word | civic-location-id id | elin-location-id id}
no location {additional-location-information word | civic-location-id id | elin-location-id id}
Modification
This command was introduced.
Chapter 2
Configure additional information for a location or place.
Configure global civic location information for an interface.
Configure emergency location information for an interface.
Specify the ID for the civic location or the elin location. The ID
range is 1 to 4095.
Specify a word or phrase that provides additional location
information.
Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03