Cisco Catalyst 2960 Command Reference Manual page 274
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (788 pages)
Table of Contents
Advertisement
mvr (global configuration)
Command Modes
Global configuration
Command History
Release
12.2(25)FX
Usage Guidelines
A maximum of 256 MVR multicast groups can be configured on a switch.
Use the mvr group command to statically set up all the IP multicast addresses that will take part in
MVR. Any multicast data sent to a configured multicast address is sent to all the source ports on the
switch and to all receiver ports that have registered to receive data on that IP multicast address.
MVR supports aliased IP multicast addresses on the switch. However, if the switch is interoperating with
Catalyst 3550 or Catalyst 3500 XL switches, you should not configure IP addresses that alias between
themselves or with the reserved IP multicast addresses (in the range 224.0.0.xxx).
The mvr querytime command applies only to receiver ports.
If the switch MVR is interoperating with Catalyst 2900 XL or Catalyst 3500 XL switches, set the
multicast mode to compatible.
When operating in compatible mode, MVR does not support IGMP dynamic joins on MVR source ports.
MVR can coexist with IGMP snooping on a switch.
Examples
This example shows how to enable MVR:
Switch(config)# mvr
Use the show mvr privileged EXEC command to display the current setting for maximum multicast
groups.
This example shows how to configure 228.1.23.4 as an IP multicast address:
Switch(config)# mvr group 228.1.23.4
This example shows how to configure ten contiguous IP multicast groups with multicast addresses from
228.1.23.1 to 228.1.23.10:
Switch(config)# mvr group 228.1.23.1 10
Use the show mvr members privileged EXEC command to display the IP multicast group addresses
configured on the switch.
This example shows how to set the maximum query response time as one second (10 tenths):
Switch(config)# mvr querytime 10
This example shows how to set VLAN 2 as the multicast VLAN:
Switch(config)# mvr vlan 2
You can verify your settings by entering the show mvr privileged EXEC command.
Catalyst 2960 Switch Command Reference
2-248
Modification
This command was introduced.
Chapter 2
Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Table of Contents
