Cisco Catalyst 2960 Command Reference Manual page 504
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (788 pages)
Table of Contents
Advertisement
snmp-server enable traps
ipmulticast
mac-notification
msdp
ospf [cisco-specific |
errors | lsa | rate-limit |
retransmit |
state-change]
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
port-security
[trap-rate value]
rtr
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
storm-control
trap-rate value
stpx
syslog
tty
vlan-membership
Catalyst 2960 Switch Command Reference
2-632
(Optional) Enable IP multicast routing traps.
(Optional) Enable MAC address notification traps.
(Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.
(Optional) Enable Open Shortest Path First (OSPF) traps. The keywords
have these meanings:
cisco-specific—(Optional) Enable Cisco-specific traps.
•
errors—(Optional) Enable error traps.
•
lsa—(Optional) Enable link-state advertisement (LSA) traps.
•
•
rate-limit—(Optional) Enable rate-limit traps.
•
retransmit—(Optional) Enable packet-retransmit traps.
state-change—(Optional) Enable state-change traps.
•
(Optional) Enable Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
invalid-pim-message—(Optional) Enable invalid PIM message traps.
•
neighbor-change—(Optional) Enable PIM neighbor-change traps.
•
rp-mapping-change—(Optional) Enable rendezvous point
•
(RP)-mapping change traps.
(Optional) Enable port security traps. Use the trap-rate keyword to set the
maximum number of port-security traps sent per second. The range is from
0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
occurrence).
(Optional) Enable SNMP Response Time Reporter traps.
(Optional) Enable SNMP traps. The keywords have these meanings:
authentication—(Optional) Enable authentication trap.
•
•
coldstart—(Optional) Enable cold start trap.
•
linkdown—(Optional) Enable linkdown trap.
linkup—(Optional) Enable linkup trap.
•
warmstart—(Optional) Enable warmstart trap.
•
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per second. The range is 0 to
1000; the default is 0 (no limit is imposed; a trap is sent at every occurrence).
(Optional) Enable SNMP STPX MIB traps. The keywords have these
meanings:
inconsistency—(Optional) Enable SNMP STPX MIB Inconsistency
•
Update traps.
root-inconsistency—(Optional) Enable SNMP STPX MIB Root
•
Inconsistency Update traps.
loop-inconsistency—(Optional) Enable SNMP STPX MIB Loop
•
Inconsistency Update traps.
(Optional) Enable SNMP syslog traps.
(Optional) Send TCP connection traps. This is enabled by default.
(Optional) Enable SNMP VLAN membership traps.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
OL-8604-03
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Table of Contents
