Spanning-Tree Mode - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

spanning-tree mode

Use the spanning-tree mode global configuration command to enable per-VLAN spanning-tree plus

(PVST+), rapid PVST+, or multiple spanning tree (MST) on your switch. Use the no form of this

command to return to the default setting.

Syntax Description

The default mode is PVST+.

Command Modes

Global configuration

Command History

Usage Guidelines

The switch supports PVST+, rapid PVST+, and MSTP, but only one version can be active at any time:

All VLANs run PVST+, all VLANs run rapid PVST+, or all VLANs run MSTP.

When you enable the MST mode, RSTP is automatically enabled.

Changing spanning-tree modes can disrupt traffic because all spanning-tree instances are stopped for the

previous mode and restarted in the new mode.

This example shows to enable MST and RSTP on the switch:

Switch(config)# spanning-tree mode mst

This example shows to enable rapid PVST+ on the switch:

Switch(config)# spanning-tree mode rapid-pvst

You can verify your setting by entering the show running-config privileged EXEC command.

Catalyst 2960 Switch Command Reference

spanning-tree mode {mst | pvst | rapid-pvst}

no spanning-tree mode

Enable MST and Rapid Spanning Tree Protocol (RSTP) (based on IEEE 802.1s and

IEEE 802.1w).

Enable PVST+ (based on IEEE 802.1D).

Enable rapid PVST+ (based on IEEE 802.1w).

Modification

This command was introduced.

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

Show Quick Links

Table of Contents