Table of Contents
Advertisement
Cabling the Supervisor Engine
Removing the 10-Gigabit Ethernet X2 Transceiver
Caution
The 10-Gigabit Ethernet X2 transceiver is a static-sensitive device. Always use an ESD wrist-strap or
similar individual grounding device when handling X2 transceivers or coming into contact with
modules.
If you are removing a 10-Gigabit Ethernet X2 transceiver, follow these steps:
Step 1
Disconnect the network fiber-optic cable from the 10-Gigabit Ethernet X2 transceiver connectors.
Immediately re-install the dust plugs in the X2 transceiver optical bores and the fiber-optic cable SC
connectors.
Step 2
Grip the sides of the 10-Gigabit Ethernet X2 transceiver sleeve with your thumb and forefinger, and pull
the sleeve out to release the X2 transceiver from the socket connector. (See
Figure 6-19
Step 3
Slide the 10-Gigabit Ethernet X2 transceiver out of the socket and immediately place it in an antistatic
bag.
Step 4
Re-install the socket cover if you are not installing an X2 transceiver in the empty socket.
a.
b.
X2 Transceiver Maintenance Guidelines
To properly maintain X2 transceivers, follow these guidelines:
•
Cisco RF Gateway 10 Hardware Installation Guide
6-24
Removing the 10-Gigabit Ethernet X2 Transceiver
1
L I N
K
A C
2
T I
V E
L I N
K
A C
Position the socket cover in front of the socket opening.
Snap the socket cover in place.
To prevent ESD damage, follow normal handling procedures.
T I
V E
Chapter 6
Cabling the Cisco RFGW-10 UEQAM
Figure
6-19.)
OL-16264-04
Advertisement
Table of Contents
