Table of Contents
Advertisement
Installation and Removal of the Fan Assembly
Figure 5-2
1
Warning
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let
the fan blades completely stop before you remove the fan tray. Statement 258
Step 2
Grasp the fan assembly handles with both hands and pull it outward to disengage the midplane connector.
Slide it out of the chassis and place it in a safe place. Do not touch the fans, hold the fan tray by the
handles only.
Installing the Fan Assembly
Follow these steps to install the new fan assembly:
Caution
Follow all installation instructions carefully to prevent damage to the connectors.
Caution
Never operate the system for more than three minutes when the fan assembly is removed. An
over-temperature condition can cause severe equipment damage.
Step 1
Place the fan assembly into the fan assembly bay so it rests on the chassis, and then lift the fan assembly
up slightly, aligning the top and sides with the bay opening.
Cisco RF Gateway 10 Hardware Installation Guide
5-8
Cisco RFGW-10 UEQAM System Fan Assembly
1
Captive installation screws
Chapter 5
Installing and Removing FRUs
OL-16264-04
Advertisement
Table of Contents
