Table of Contents
Advertisement
Chapter 1
Overview
1 Supervisor Engine slots 1 and 2
2 Universal RF card slots 3 through 12
Figure 1-3
Cisco RFGW-10 Components
The following sections describe the components in the Cisco RFGW-10:
•
•
•
•
•
•
•
•
•
Fan Assembly
The Cisco RFGW-10 UEQAM system uses a modular fan assembly to dissipate heat from the system
and control the temperature of the chassis system components (except the DC PEM, which contains its
own internal fan). The fan assembly is a multi-fan design that pulls ambient air from the lower front of
the chassis and exhausts air out of the rear top of the chassis. The fan assembly provides individual fan
control and failure monitoring, multiple thermistors to monitor exhaust air and a wide range of speed
control parameters based on the system and the environmental conditions. Inlet air monitoring is
communicated to the fan tray via the system software from the sensors on each of the RF line cards.
The fan tray module provides the following features:
OL-16264-04
Cisco RFGW-10 Slot/Port Numbering
Fan Assembly, page 1-7
DC PEMs, page 1-10
Front Panel Display, page 1-14
Supervisor Engines, page 1-15
Cisco RFGW 10 Supervisor Engine 7-E, page 1-17
Cisco RFGW-10 DS-48 Line Card, page 1-20
Cisco RFGW-10 DS-384 Line Card, page 1-23
TCC/DTI Card, page 1-23
RF Switch Card, page 1-27
3 RF Switch slots 1 through 12
4 TCC cards slots 13 and 14
Cisco RF Gateway 10 Hardware Installation Guide
Cisco RFGW-10 Components
1-7
Advertisement
Table of Contents
