Table of Contents
Advertisement
Chapter 6
Cabling the Cisco RFGW-10 UEQAM
Figure 6-6
Safety Information and Warnings
Following are the safety guidelines that you should follow when working with any equipment that
connects to the electrical power.
Electrical Equipment Guidelines
Follow these basic guidelines when working with any electrical equipment:
•
•
•
•
•
•
OL-16264-04
Nominal Attenuation Graph for 75-Ohm Miniature Headend Coaxial Cable
0
-2
-4
-6
-8
-10
-12
0
100
200
Before beginning any procedure requiring access to the chassis interior, locate the emergency
power-off switch for the room you are working in.
Disconnect all the power and external cables before moving a chassis.
Do not work alone when potentially hazardous conditions exist.
Never assume that the power has been disconnected from a circuit. Always check before proceeding.
Do not perform any action that would result in a potential hazard or make the equipment unsafe.
Carefully examine your work area for possible hazards such as moist floor, ungrounded power
extension cables, and missing safety grounds.
NOM ATTENUATION GRAPH
300
400
500
FREQ (MHz)
NOM ATTEN (dB/10-0-ft)
Cisco RF Gateway 10 Hardware Installation Guide
Safety Information and Warnings
600
700
800
900
1000
6-7
Advertisement
Table of Contents
