Table of Contents
Advertisement
Chapter 5
Installing and Removing FRUs
Step 10
Use a screwdriver to tighten the captive installation screws on each end of the Supervisor Card's
faceplate.
Note
Tighten the captive screws to 6-8 in-lbs.
Verifying the Status of the Supervisor Card
To check the status of the module, do the following:
Step 1
Ensure that the STATUS LED illuminates green (module operational).
Step 2
When the supervisor is online, enter the show module all command. Verify that the system
acknowledges the new module and that the module's status is good.
Step 3
If the module is not operational, re-seat it. If the module is still not operational, contact your customer
service representative.
Removing the Supervisor Card
Note
If you are removing a Supervisor card from the chassis when the system is up and running, ensure that
the card is in the standby mode. If the card is in active mode, execute the redundancy force-switchover
command to change the card to the Standby mode, and then remove the card from the chassis.
Caution
When no fiber cable is connected, the aperture of the port may be emitting invisible radiation. Avoid
exposure to the radiation and do not stare into the apertures.
Caution
During this procedure, wear grounding wrist-straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool. This could result in an electric shock.
Caution
To prevent ESD damage, handle the Supervisor Cards by the carrier edges only.
To remove a Supervisor Card from a Cisco RFGW-10 UEQAM, do the following:
Step 1
Disconnect the network interface cables attached to the ports on the Supervisor Card that you intend to
remove.
Step 2
Loosen the captive installation screws (see
OL-16264-04
Installation and Removal of the Supervisor Cards
Figure
5-5).
Cisco RF Gateway 10 Hardware Installation Guide
5-13
Advertisement
Table of Contents
