Table of Contents
Advertisement
Chapter 3
Cisco RFGW-10 UEQAM Installation
Installing the Cisco RFGW-10 UEQAM in a Rack
Note
If you are using the chassis installation handles on the front rack-mount brackets, you must first remove
the handles to install the fourth screw.
Step 8
Ensure that all screws on each side rack-mount brackets are tightened to the equipment rack then the
chassis installation brackets can be removed from the rack (see
Figure
3-10).
Figure 3-10
Securing the Side Rack-Mount Brackets
You can install your Cisco RFGW-10 chassis in a two-post rack (see
"Two-Post Rack Installation
Mid-Mounted" section on page
3-16) or a four-post rack.
Cisco RF Gateway 10 Hardware Installation Guide
3-15
OL-16264-04
Advertisement
Table of Contents
