Table of Contents
Advertisement
Installing the Chassis Installation Handles
Note
Chassis installation handles should not be installed if the chassis is to be mid mounted.
To install the chassis installation handles on a Cisco RFGW-10 UEQAM, complete the following steps:
Step 1
Locate the two M5 threaded holes on the upper center of each side of the chassis that align with the
handle captive screws. (See
Step 2
Install the two chassis installation handles on either side of the chassis and tighten the captive screws.
Caution
Ensure that the captive screws are secured tightly prior to loading the handles to prevent injury or
damage to the chassis.
Figure 3-5
After the chassis rack-mount brackets are installed, additional handles can be installed onto the front of
the rack-mount brackets. The rack-mount brackets allow a low and high installation of the handles onto
the bracket depending on the chassis installation (low or high in the rack).
Cisco RF Gateway 10 Hardware Installation Guide
3-8
Figure
3-5.)
Attaching the Chassis Installation Handles to the Cisco RFGW-10 UEQAM
Chapter 3
Cisco RFGW-10 UEQAM Installation
OL-16264-04
Advertisement
Table of Contents
