Table of Contents
Advertisement
Chapter 3
Cisco RFGW-10 UEQAM Installation
Attaching the Chassis Rack-Mount Brackets
This section explains how to attach the front and the mid rack-mount brackets to the chassis. Before
installing the chassis in the rack, you must install the rack-mount brackets on each side of the chassis.
The parts and tools required for installing the rack-mount brackets, chassis installation handles, chassis
installation bracket, and the cable management brackets are listed in the
on page
Note
The rear RF cable-management bracket is installed on the chassis after you install the chassis rack-mount
brackets and mount the chassis in the rack.
Chassis Front Rack-Mount Brackets Installation
To install the front rack-mount brackets on a Cisco RFGW-10 UEQAM, complete the following steps:
Step 1
Locate the threaded holes on the front sides of the chassis that align with the holes in the rack-mount
bracket. Ensure that you hold the front rack-mount bracket with the ear and holes facing outward and
towards the front of the chassis (see
Step 2
Install all six M5 undercut flat-head screws (provided in the accessory kit) to secure each of the
rack-mounting bracket to the chassis. There will be three screws installed on each end of the
rack-mounting bracket.
Step 3
Repeat Step 1 through Step 2 on the other side of the chassis.
Step 4
Install the chassis in the rack. To install the Cisco RFGW-10 UEQAM in the rack, go to
Cisco RFGW-10 UEQAM in a Rack" section on page
OL-16264-04
2-19.
Figure
3-6).
3-12.
Cisco RF Gateway 10 Hardware Installation Guide
Attaching the Chassis Rack-Mount Brackets
"Tools and Equipment" section
"Installing the
3-9
Advertisement
Table of Contents
