Show Ipv6 Interface - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
Chapter 22
Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show ipv6 interface
To display IPv6 interface status and configuration information, use the show ipv6 interface command.
Syntax Description
gigabitethernet
slot/port
mgmt 0
port-channel
port-channel-number
vsan
vsan-id
Defaults
None.
Command Modes
EXEC mode.
Command History
Release
3.1(0)
Usage Guidelines
None.
Examples
The following example displaysIPv6 interface information.
switch# show ipv6 interface
GigabitEthernet1/2 is up
IPv6 is enabled
Global address(es):
Link-local address(es):
ND DAD is disabled
ND reachable time is 30000 milliseconds
ND retransmission time is 1000 milliseconds
Stateless autoconfig for addresses disabled
GigabitEthernet2/2 is up
IPv6 is enabled
Global address(es):
Link-local address(es):
ND DAD is disabled
OL-8413-07, Cisco MDS SAN-OS Release 3.x
show ipv6 interface [gigabitethernet slot/port | mgmt 0 | port-channel port-channel-number |
vsan vsan-id]
Displays a Gigabit Ethernet interface.
Displays the management interface.
Displays a PortChannel interface.
Specifies the PortChannel number. The range is 1 to 128.
Displays an IPFC VSAN interface.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
5000::1/64
fe80::205:30ff:fe01:a6bf
6000::1/64
fe80::205:30ff:fe00:a413
Cisco MDS 9000 Family Command Reference
show ipv6 interface
22-159
Advertisement
Table of Contents
