Santap Module - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
santap module
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
santap module
To configure the mapping between the Storage Services Module (SSM) and the VSAN where the
appliance is configured, use the santap module command in configuration mode. To disable this feature,
use the no form of the command.
Syntax Description
slot-number
appl-vsan vsan-id
cvt-name cvt-name
dvt
target-pwwn
target-pwwn
target-vsan
target-vsan-id
dvt-name dvt-name
dvt-vsan dvt-vsan-id
dvt-port port-number
lun-size-handling
enable/disable
io-timeout
timeout-value
Defaults
Disabled.
The IO-timeout is 10 seconds.
Lun-size-handling is Enabled.
Command Modes
Configuration mode.
Cisco MDS 9000 Family Command Reference
21-4
santap module slot-number {appl-vsan vsan-id [cvt-name cvt-name] |
dvt target-pwwn target-pwwn target-vsan target-vsan-id dvt-name dvt-name dvt-vsan
dvt-vsan-id [dvt-port port-number] [lun-size-handling enable/disable] [io-timeout
timeout-value]}
no santap module slot-number {appl-vsan vsan-id [cvt-name cvt-name] |
dvt target-pwwn target-pwwn}
Specifies the slot number of the SSM where the control virtual target (CVT) is
created.
Specifies the appliance VSAN identification number used to communicate
with the appliance. The range is 1 to 4093.
Specifies the control virtual target (CVT) name. The maximum size is 80
characters.
Configures the data virtual target (DVT).
Specifies the target pWWN for the DVT. The format is
hh:hh:hh:hh:hh:hh:hh:hh.
Specifies the target VSAN for the DVT. The range for the real target-vsan-id
is 1 through 4093.
Specifies the DVT name. The maximum size is 80 characters.
Specifies the DVT VSAN. The range for the dvt-vsan-id is 1 through 4093.
Specifies the DVT port. The range for the port number is 1 through 32.
Enables or disables LUN size handling. Specify 1 to enable or 0 to disable
LUN size handling, with the default being enable.
Specifies the I/O timeout value. The range is 10 to 200 seconds, with the
default being 10 seconds.
Chapter 21
S Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Advertisement
Table of Contents
