Fcs Virtual-Device-Add - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
Chapter 8
F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fcs virtual-device-add
To include a virtual device in a query about zone information from an FCS, use the fcs
virtual-device-add command in configuration mode. To remove a virtual device, use the no form of the
command.
Syntax Description
vsan-ranges vsan-ids
Defaults
Disabled.
Command Modes
Configuration mode.
Command History
Release
3.1(2)
Usage Guidelines
VSAN ranges are entered as vsan-ids-vsan-ids. When you specify more than one range, separate each
range with a comma. If no range is specified, the command applies to all VSANs.
Examples
The following example shows how to add to one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4
The following example shows how to add to more than one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4,5-8
Related Commands
Command
show fcs
OL-8413-07, Cisco MDS SAN-OS Release 3.x
fcs virtual-device-add [vsan-ranges vsan-ids]
no fcs virtual-device-add [vsan-ranges vsan-ids]
Specifies one or multiple ranges of VSANs. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays fabric configuration server information.
Cisco MDS 9000 Family Command Reference
fcs virtual-device-add
8-43
Advertisement
Table of Contents
