Logging Logfile - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
Chapter 14
L Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
logging logfile
To set message logging for logfile, use the logging logfile command.To negate the previously issued
command or to revert to factory defaults, use the no form of the command.
Syntax Description
filename
severity-level
size filesize
Defaults
None.
Command Modes
Configuration mode.
Command History
Release
1.0(2)
Usage Guidelines
The switch logs messages at or above the configured severity level.
Examples
The following example configures logging information for errors or events above a severity level of 3
(errors) to be logged in a file named ManagerLogFile. By configuring this limit, the file size is restricted
to 3,000,000 bytes.
switch# config terminal
switch(config)# logging logfile ManagerLogFile 3 size 3000000
Related Commands
Command
show logging
OL-8413-07, Cisco MDS SAN-OS Release 3.x
logging logfile filename severity-level [size filesize]
no logging logfile
Specifies the log filename. Maximum length is 80 characters.
Specifies the maximum severity of messages logged. The range is 0 to 7,
where 0 is emergency, 1 is alert, 2 is critical, 3 is error, 4 is warning, 5 is
notify, 6 is informational, and 7 is debugging.
Specifies the log file size. The range is 4096 to 4194304 bytes.
Modification
This command was introduced.
Description
Displays logging configuration information.
Cisco MDS 9000 Family Command Reference
logging logfile
14-17
Advertisement
Table of Contents
