Radius-Server Deadtime - Cisco MDS 9000 series Command Reference Manual

Hide thumbs Also See for MDS 9000 series:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

radius-server deadtime

To set a periodic time interval where a nonreachable (nonresponsive) RADIUS server is monitored for

responsiveness, use the radius-server deadtime command. To disable the monitoring of the

nonresponsive RADIUS server, use the no form of the command.

Syntax Description

Command Modes

Configuration mode.

Command History

Usage Guidelines

Setting the time interval to zero disables the timer. If the dead time interval for an individual RADIUS

server is greater than zero (0), that value takes precedence over the value set for the server group.

When the dead time interval is 0 minutes, RADIUS server monitoring is not performed unless the

RADIUS server is part of a server group and the dead time interval for the group is greater than 0

The following example shows how to set a duration of 10 minutes.

switch# config terminal

switch(config)# radius-server deadtime 10

Related Commands

show radius-server

OL-8413-07, Cisco MDS SAN-OS Release 3.x

radius-server deadtime time

no radius-server deadtime time

Specifies the time interval in minutes. The range is 1 to 1440.

Modification

This command was introduced.

Sets a time interval for monitoring a nonresponsive RADIUS server.

Displays all configured RADIUS server parameters.

Cisco MDS 9000 Family Command Reference

radius-server deadtime