Ips Netsim Delay-Ms - Cisco MDS 9000 series Command Reference Manual

Hide thumbs Also See for MDS 9000 series:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ips netsim delay-ms

To delay packets that arrive at a specified Gigabit Ethernet interface specifying milliseconds, use the ips

netsim delay command in SAN extension tuner configuration submode.

Syntax Description

delay-ms milliseconds

gigabitethernet

Command Modes

SAN extension tuner configuration submode.

Command History

Usage Guidelines

To use this command, you must enable the IP Network Simulator using the ips netsim enable command.

This command introduces a delay for all packets entering the Gigabit Ethernet interface. Delay is

unidirectional. To introduce delay in the opposite direction, use the slot and port number of the adjacent

The following example shows how to configure a delay of 50 milliseconds for packets entering Gigabit

Ethernet interface 2/3.

switch# config terminal

switch(config)#

switch(config)# san-ext-tuner enable

switch(config)# exit

switch# ips netsim delay-ms 50 ingress gigabitethernet 2/3

Related Commands

show ips netsim

ips netsim enable

OL-8413-07, Cisco MDS SAN-OS Release 3.x

ips netsim delay-ms milliseconds ingress gigabitethernet slot/port

Specifies the delay in milliseconds. The range is 0 to 150.

Specifies the ingress direction.

Specifies the the slot and port number of the Gigabit Ethernet interface.

Modification

This command was introduced.

Displays a summary of the interfaces that are currently operating in network

simulation mode.

Enables the IP Network Simulator.

Cisco MDS 9000 Family Command Reference

ips netsim delay-ms