Cisco MDS 9000 series Command Reference Manual page 873

Hide thumbs Also See for MDS 9000 series:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Command History

Usage Guidelines

To access this command, you must first enable the SANTap feature on the SSM using the ssm enable

feature command.

When the lun-size-handling option is set (enabled), the maximum logical block addressing (LBA) for

DVT LUN is set to 2 TB. As a result, there is no issue with LUN resizing.

You can delete dvt target-pwwn using the no santap module slot dvt target-pwwn command. Other

dvt options are not supported by the no form of the command.

The following example shows the configuration of the SSM where the SANTap feature is enabled and

the VSAN used to communicate with the appliance.

switch# config terminal

Enter configuration commands, one per line.

switch(config)# santap module 1 appl-vsan 1

Related Commands

ssm enable feature

show santap module

OL-8413-07, Cisco MDS SAN-OS Release 3.x

Modification

This command was introduced.

Added the following options: cvt-name, dvt, target-pwwn, target-vsan,

dvt-name, dvt-vsan, dvt-port, lun-size-handling, and io-timeout.

Enables the SANTap feature on the SSM.

Displays the configuration and statistics of the SANTap feature.

End with CNTL/Z.

Cisco MDS 9000 Family Command Reference

santap module