Sdv Commit Vsan - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
sdv commit vsan
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
sdv commit vsan
To commit an SDV configuration to a specified VSAN, use the sdv commit vsan command in
configuration mode. To remove the SDV configuration for a specified VSAN, use the no form of the
command.
Syntax Description
commit
vsan vsan-id
Defaults
Disabled.
Command Modes
Configuration mode.
Command History
Release
3.1(2)
Usage Guidelines
To use this command, you must enable SDV using the sdv enable command.
Examples
The following example shows how to commit an SDV configuration to a specified VSAN.
switch# config t
Enter configuration commands, one per line.
switch(config)# sdv commit vsan 2
The following example shows how to uncommit an SDV configuration from a specified VSAN.
switch# config t
Enter configuration commands, one per line.
switch(config)# no sdv commit vsan 2
Related Commands
Command
show sdv database
sdv enable
Cisco MDS 9000 Family Command Reference
21-14
sdv commit vsan vsan-id
no sdv commit vsan vsan-id
Commits the SDV configuration.
Specifies the number of the VSAN. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays the SDV database.
Enables SDV.
End with CNTL/Z.
End with CNTL/Z.
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 21
S Commands
Advertisement
Table of Contents
