Nasb Rediscover Module - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
nasb rediscover module
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
nasb rediscover module
To initiate the rediscovery of a target device, such as a disk or tape device, used for Network-Accelerated
Serverless Backup (NASB) in a VSAN on a Storage Services Module (SSM) where the feature is
enabled, use the nasb rediscover module command in EXEC mode.
Syntax Description
slot-number
vsan vsan-id
target-pwwn pwwn-id
Defaults
None.
Command Modes
EXEC mode.
Command History
Release
2.1(2)
Usage Guidelines
None.
Examples
The following example shows how to initiate a rediscovery of a target device.
switch# nasb rediscover module 2 vsan 9 target-pwwn 20:02:00:a0:b8:16:a1:5f
nasb rediscovery initiated
switch#
Related Commands
Command
nasb module
show nasb
ssm enable feature
Cisco MDS 9000 Family Command Reference
16-4
nasb rediscover module slot-number vsan vsan-id target-pwwn pwwn-id
Specifies the slot number of the connected module.
Specifies the current VSAN. The range is 1 to 4096.
Specifies the pWWN for the target device. The form is
hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number.
Modification
This command was introduced.
Description
Enables the NASB feature in configuration mode and allows you to
configure the Storage Array Controller and multiple LUNs.
Displays the NASB configuration on the SSM.
Enables the NASB feature on the SSM.
Chapter 16
N Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Advertisement
Table of Contents
