Ipv6 Address Autoconfig - Cisco MDS 9000 series Command Reference Manual

Hide thumbs Also See for MDS 9000 series:

Table of Contents

ipv6 address autoconfig

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ipv6 address autoconfig

To enable automatic configuration of IPv6 addresses using stateless autoconfiguration on an interface

and enable IPv6 processing on the interface, use the ipv6 address autoconfig command in interface

configuration submode. To remove the address from the interface, use the no form of the command.

Syntax Description

This command has no arguments or keywords.

Command Modes

Interface configuration submode.

Command History

Usage Guidelines

You can use the ipv6 address autoconfig command to enable IPv6 stateless autoconfiguration on the

specified interface. For additional information about autoconfiguration, refer to the Cisco MDS 9000

Family CLI Configuration Guide.

The following example assigns enables IPv6 stateless autoconfiguration on the interface.

switch# config terminal

Enter configuration commands, one per line. End with CNTL/Z.

switch(config)# interface gigabitethernet 2/2

switch(config-if)# ipv6 address autoconfig

Related Commands

ipv6 address

ipv6 traffic-filter

show interface

Cisco MDS 9000 Family Command Reference

ipv6 address autoconfig

no ipv6 address autoconfig

Modification

This command was introduced.

Enables IPv6 processing and configures an IPv6 address on an interface.

Enables IPv6 processing on the interface.

Configures IPv6 neighbor discovery commands on the interface.

Configures IPv6 ACLs to filter traffic for packets on the interface.

Displays interface configuration information.

OL-8413-07, Cisco MDS SAN-OS Release 3.x