Ipv6 Traffic-Filter - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
Chapter 11
I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ipv6 traffic-filter
To configure IPv6 access control lists (ACLs) to filter traffic for packets on the interface, use the ipv6
traffic-filter command in interface configuration submode. To remove an IPv6-ACL traffic filter on the
switch, use the no form of the command.
Syntax Description
access-list-name
in
out
Defaults
None.
Command Modes
Interface configuration submode.
Command History
Release
3.0(1)
Usage Guidelines
None.
Examples
The following example configures a traffic filter, called testfilter, for inbound packets.
switch# config terminal
switch(config)# interface gigabitethernet 2/2
switch(config-if)# ipv6 traffic-filter testfilter in
Related Commands
ipv6 address
ipv6 enable
ipv6 nd
show interface
OL-8413-07, Cisco MDS SAN-OS Release 3.x
ipv6 traffic-filter access-list-name {in | out}
no ipv6 traffic-filter access-list-name {in | out}
Specifies the name of an access control list for packets. The maximum size
is 64 characters.
Configures inbound packets.
Configures outbound packets.
Modification
This command was introduced.
Configures the IPv6 address and enables IPv6 processing.
Enables IPv6 processing on the interface.
Configures IPv6 ACLs to filter traffic for packets on the interface.
Displays interface configuration information.
Cisco MDS 9000 Family Command Reference
ipv6 traffic-filter
11-77
Advertisement
Table of Contents
