Fspf Dead-Interval - Cisco MDS 9000 series Command Reference Manual

Hide thumbs Also See for MDS 9000 series:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fspf dead-interval

To set the maximum interval for which a hello message must be received before the neighbor is

considered lost, use the fspf dead-interval command. To revert to the default value, use the no form of

the command.

Syntax Description

vsan vsan-id

Command Modes

Interface configuration submode.

Command History

Usage Guidelines

Access this command from the

This value must be the same in the ports at both ends of the ISL.

An error is reported at the command prompt if the configured dead time interval is less than the hello

time interval.

The following example configures the maximum interval of 400 seconds for a hello message before the

neighbor is considered lost.

switch# config terminal

switch(config)# interface fcip 1

switch(config-if)# fspf dead-interval 4000 vsan 1

Related Commands

show fspf interface

show interface fcip

OL-8413-07, Cisco MDS SAN-OS Release 3.x

fspf dead-interval seconds vsan vsan-id

no fspf dead-interval seconds vsan vsan-id

Modification

This command was introduced.

Displays information for each selected interface.

Displays an interface configuration for a specified FCIP interface.

Specifies the FSPF dead interval in seconds. The rage is 2 to 65535.

Specifies a VSAN ID. The range is 1 to 4093.

switch(config-if)#

Cisco MDS 9000 Family Command Reference

fspf dead-interval