Cisco 3825 Software Configuration Manual page 168
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
ima-group
ima-group
To define physical links as inverse multiplexing over ATM (IMA) group members, use the ima-group
Interface configuration command. When you first perform the configuration or when you change the
group number, the interface is automatically disabled, moved to the new group, and then enabled. To
remove the port from the group, use the no form of this command.
Syntax Description
group-number
Defaults
Physical links are not included in IMA groups.
Command Modes
Interface configuration
Command History
Release
12.0(5)XK
12.4(4)MR
Usage Guidelines
Use the ima-group interface command to configure a T1/E1 IMA port adapter interface as part of an
IMA group.
Examples
The following example shows how to define an IMA group:
Router(config)# interface ATM0/0/0
Router(config-if)# no ip address
Router(config-if)# no atm ilmi-keepalive
Router(config-if)# ima-group 0
Related Commands
Command
interface atm
interface atm ima
show ima interface atm
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-36
ima-group group-number
Specifies an IMA group number from 0 to 3. IMA groups can span multiple
ports on a port adapter but cannot span port adapters.
Modification
This command was introduced.
This command was incorporated.
Appendix A
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
Configures an ATM interface.
Configures an ATM IMA group.
Provides information about configured IMA groups or a specific IMA
group.
OL-15667-03
Hide quick links:
Advertisement
Table of Contents
