Ipran-Mib Backhaul-Notify-Interval - Cisco 3825 Software Configuration Manual
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Appendix A
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
ipran-mib backhaul-notify-interval
Use the ipran-mib backhaul-notify-interval command in the global configuration mode to specify the
interval used to suppress the generation of the ciscoIpRanBackHaulRcvdUtil and the
ciscoIpRanBackHaulSentUtil notifications from the CISCO-IP-RAN-BACKHAUL-MIB.
To set the interval used to suppress notifications, use the following configuration command or the no
form of this command to remove the interval:
Notifications are suppressed for the number of seconds specified. Notifications are not suppressed when
this keyword is set to zero. The minimum interval is one minute and the maximum is fifteen minutes.
When suppression is enabled, notifications are generated when a worse state is encountered. For
example, the following transitions generate notifications:
•
•
Later transitions to lesser states are suppressed. For example, the following transitions do not generate
notifications:
•
•
•
At the end of the specified interval, a notification is generated if the current state is different from the
state reported by the last notification.
Syntax Description
ipran-mib
backhaul-notify-interval
Defaults
Defaults to 0 (notifications are not suppressed).
Command Modes
Interface configuration
Command History
Release
12.4(2)MR1
12.4(9)MR
Examples
Router# config t
Router(config)# ipran-mib backhaul-notify-interval 60
Router(config)# ipran-mib backhaul-notify-interval 900
Router(config)# no ipran-mib backhaul-notify-interval
Router(config)# exit
OL-15667-03
ipran-mib backhaul-notify-interval 60-900 seconds
"acceptable" to "warning"
"warning" to "overloaded"
"warning" to "acceptable"
"overloaded" to "warning"
"overloaded" to "acceptable"
60-900 seconds
Modification
This command was introduced.
Support for utilization notification was removed. This command is supported to
maintain compatibility.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
ipran-mib backhaul-notify-interval
A-49
Hide quick links:
Advertisement
Table of Contents
