Cisco 3825 Software Configuration Manual page 201
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Appendix A
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
sample-rate
To specify in milliseconds the rate hardware samples the data on the attached circuit, use the
sample-rate command in the circuit emulation (CEM) circuit configuration mode.
Syntax Description
sample rate
Command Modes
CEM circuit configuration
Command History
Release
12.4(12)MR2
Examples
The following example illustrates the use of the sample-rate command:
Router# config t
Router(config)# interface cem 0/0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# sample-rate 2
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Command
Related Commands
cem
cem class
class cem
OL-15667-03
sample-rate [sample-rate]
Sample rate translates into the payload-size sent over the circuit. The default
is 1 ms.
32-timeslots at 1ms = 256-bytes (32-timeslots * 8-bytes/timeslot/ms)
•
24-timeslots at 2ms = 384-bytes (24-timeslots * 16-bytes/timeslot/ms)
•
Modification
This command was introduced.
Description
Apply CEM class.
Applies the CEM interface parameters defined in the given
<cem-class-name> to the circuit.
Configure's CEM interface parameters in a class that's applied to
CEM interfaces together in the global configuration mode.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
sample-rate
A-69
Hide quick links:
Advertisement
Table of Contents
