Cisco 3825 Software Configuration Manual page 92
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Configuration Sequence
To configure a Cisco 3825 for SNMP, follow these steps while in the global configuration mode:
To set up the community access string to permit access to the SNMP, use the snmp-server community
Step 1
command. The no form of this command removes the specified community string.
Router(config)# snmp-server community string [view view-name ] [ro | rw] [ number ]
Where:
string—Community string that acts like a password and permits access to the SNMP protocol.
•
view view-name—(Optional) Name of a previously defined view. The view defines the objects
•
available to the community.
ro—(Optional) Specifies read-only access. Authorized management stations are only able to
•
retrieve MIB objects.
rw—(Optional) Specifies read-write access. Authorized management stations are able to both
•
retrieve and modify MIB objects.
number—(Optional) Integer from 1 to 99 that specifies an access list of IP addresses that are allowed
•
to use the community string to gain access to the SNMP agent.
For example, the following command sets up the community access string as xxxxx with read-only
access:
Router(config)# snmp-server community xxxxx RO
To establish the message queue length for each trap host, use the snmp-server queue-length command.
Step 2
Router(config)# snmp-server queue-length length
Where length is the integer that specifies the number of trap events that can be held before the queue
must be emptied.
For example, the following command establishes the number of trap events to 100:
Router(config)# snmp-server queue-length 100
To enable the router to send SNMP traps or informs (SNMP notifications), use the snmp-server enable
Step 3
traps command. Use the no form of this command to disable SNMP notifications.
Router(config)# snmp-server enable traps [ notification-type ] [ notification-option ]
Where:
notification-type—snmp [authentication]—Enables RFC 1157 SNMP notifications. Note that use
•
of the authentication keyword produces the same effect as not using the authentication keyword.
Both the snmp-server enable traps snmp and snmp-server enable traps snmp authentication
forms of this command will globally enable (or, if using the no form, disable) the following SNMP
traps:
–
–
–
–
–
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-34
Chapter 4
Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
authentication failure
linkup
linkdown
coldstart
warmstart
OL-15667-03
Hide quick links:
Advertisement
Table of Contents
