Creating A Policy Map - Cisco 3825 Software Configuration Manual
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Chapter 4
Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Creating a Class Map
For each class map that you want to create, follow these steps, while in global configuration mode:
Assign a name to your class map.
Step 1
Router(config)# class-map [match-all | match-any] class_name
Where match-any means that a single match rule is sufficient for class membership and match-all
means that only packets that have all the specified attributes are part of the class.
For example, the following command specifies the class map as an llq-class:
Router(config)# class-map match-any llq-class
When you enter the class-map command, you are in the class map configuration mode.
To identify a specific IP differentiated service code point (DSCP) value as a match criterion, use the
Step 2
following command:
Router(config-cmap)# match ip dscp value
Where match ip dscp value specifies the exact value from 0 to 63 used to identify an IP DSCP value.
For example, the following command specifies cs2 to be used as a match criterion:
Router(config-cmap)# match ip dscp cs2
For more information about this command, see the Cisco IOS Quality of Service Solutions Command
Reference for your Cisco IOS Release.
Exit the class map configuration mode.
Step 3
Router(config-cmap)# exit
Creating a Policy Map
To create a policy map, follow these steps, while in the global configuration mode:
Step 1
Assign a name to your policy map.
Router(config)# policy-map policy_name
Where policy_name specifies the name of the traffic policy. The traffic policy may contain one or more
traffic classes.
For example, the following command specifies the policy map of low latency queueing (LLQ).
Router(config)# policy-map llq-policy
When you enter the policy-map command, you are in the policy map configuration mode.
Step 2
Associate the llq-policy with a class map.
Router(config-pmap)# class class_name
Where class_name specifies the name of a traffic class you want to modify.
Specify the same class_name as you did in Step 1in the
OL-15667-03
"Creating a Class Map" section on page
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
Configuration Sequence
4-47.
4-47
Hide quick links:
Advertisement
Table of Contents
