Cisco 3825 Software Configuration Manual page 265
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Appendix A
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
xconnect
To bind an attachment circuit to a pseudowire (PW), use the xconnect command in one of the supported
configuration modes. To restore the default values, use the no form of this command.
Syntax Description
peer-ip-address
vcid
pseudowire-parameters Encapsulation and pseudowire-class parameters to be used for the
sequencing
transmit
receive
both
one-to-one
ignore-vpi-vci
Defaults
The attachment circuit is not bound to the PW.
Command Modes
CEM circuit configuration
Interface configuration
Subinterface configuration
OL-15667-03
xconnect peer-ip-address | vcid | pseudowire-parameters [sequencing {transmit | receive | both |
one-to-one}] [ignore-vpi-vci]
IP address of the remote provider edge (PE) peer.
The 32-bit identifier of the virtual circuit between the PE routers.
attachment circuit. At least one of the following PW parameters must be
configured:
•
•
(Optional) Sets the sequencing method to be used for packets received or
sent.
Note
Sequences data packets received from the attachment circuit.
Sequences data packets sent into the attachment circuit.
Sequences data packets that are both sent and received from the attachment
circuit.
Only apply when the xconnect command is configured under the AAL0
encapsulation PVC. It specifies the PW type as a one-to-one VCC cell relay.
With the ignore-vpi-vci keyword configured, the MWR ignores the
VPI/VCI value in the PW packet and does a blind rewrite with the local
configured AC-side PVC's VPI/VCI value. Only apply when the xconnect
command is configured under the PVC, which is the N:1 with N=1 special
case. Do not apply when the xconnect command is configured under the
subinterface, which supports N>1.
encapsulation {l2tpv3 | mpls}— Specifies the tunneling method to
encapsulate the data in the PW:
l2tpv3—Specifies L2TPv3 as the tunneling method.
–
mpls—Specifies MPLS as the tunneling method.
–
pw-class pw-class-name—Specifies the pseudowire-class
configuration from which the data encapsulation type is taken. This
option is mandatory if you select an encapsulation method.
Sequencing is not supported for CEM circuits.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
xconnect
A-133
Hide quick links:
Advertisement
Table of Contents
