Cisco 3825 Software Configuration Manual page 90
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Configuration Sequence
Step 15
To configure the name of the standby group, use the standby name command in interface configuration
mode. To disable the name, use the no form of this command.
Router(config-if)# standby [ group-number ] name [ group-name ]
Where:
•
group-number—Specifies the standby group number.
group-name—Specifies the name of the standby group.
•
For example, the following command specifies the hot standby group name as one:
Router(config-if)# standby 1 name_one
Note
If you omit the group-name or if you enter a group name that does not begin with one or two, the
Caution
configuration will fail and there will be a mismatch in the information displayed by the show
redundancy and show standby commands.
Step 16
To configure HSRP to track an object and change the Hot Standby priority based on the state of the
object, use the standby track command in interface configuration mode. To remove the tracking, use
the no form of this command.
Note
Router(config-if)# standby [group-number] track interface-type interface-number
[ interface-priority ]
Where:
group-number—(Optional) Group number to which the tracking applies.
•
interface-type—Interface type (combined with interface number) that will be tracked.
•
interface-number—Interface number (combined with interface type) that will be tracked.
•
interface-priority—(Optional) Amount by which the Hot Standby priority for the router is
•
decremented (or incremented) when the interface goes down (or comes back up). The default value
is 10.
For example, the following command specifies the hot standby group 1 to track Loopback 103 interface:
Router(config-if)# standby 1 track Loopback103
Note
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-32
Chapter 4
Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Typically, only one GE is used in a RAN-O solution. So, the command must be standby 1
name_one.
When you use the Cisco 3825 router in a RAN-O solution, you must configure the GE interface
to track the multilink interface and the loopback interface.
In redundant configurations, you should issue standby track commands for both the health
interface (loopback101), the revertive interface (loopback102), the backhaul interface
(multilink1), and shorthaul interface (loopback 103). The decrement values must be as follows:
10 for the multilink, GE, and health interfaces; 5 for the revertive interface.
OL-15667-03
Hide quick links:
Advertisement
Table of Contents
