Cisco 3825 Software Configuration Manual page 229
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Appendix A
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Table A-4
Field
Status
The following example shows information about the NSF/SSO and graceful restart capability. The SSO
portion indicates when checkpointing data has either been sent (on active) or received (on standby).
When SSO data has not been successfully sent or has been released, the SSO information is not shown.
Router# show mpls l2transport vc detail
Local interface: Fa0/1.1 down, line protocol down, Eth VLAN 2 up
Destination address: 10.55.55.2, VC ID: 1002, VC status: down
Output interface: Fa0/0, imposed label stack {16}
Preferred path: not configured
Default path: active
Tunnel label: imp-null, next hop point2point
Create time: 02:03:29, last status change time: 02:03:26
Signaling protocol: LDP, peer 10.55.55.2:0 down
MPLS VC labels: local 16, remote unassigned
Group ID: local 0, remote unknown
MTU: local 1500, remote unknown
Remote interface description:
Sequencing: receive disabled, send disabled
SSO Descriptor: 10.55.55.2/1002, local label: 16
SSM segment/switch IDs: 12290/8193, PWID: 8193
VC statistics:
packet totals: receive 0, send 0
byte totals:
packet drops:
Table A-5
Table A-5
Field
line protocol
Destination address IP address of the remote router specified for this VC. Specify the destination IP
OL-15667-03
show mpls l2transport vc Field Descriptions (continued)
Description
The status of the VC. The status can be one of the following:
UP—The VC is in a state where it can carry traffic between the two VC
•
endpoints. A VC is up when both imposition and disposition interfaces are
programmed.
The disposition interface is programmed if the VC has been configured
–
and the client interface is up.
The imposition interface is programmed if the disposition interface is
–
programmed and you have a remote VC label and an Interior Gateway
Protocol (IGP) label. The IGP label can be implicit null in a back-to-back
configuration. An IGP label means there is a Label Switched Path (LSP)
to the peer.
DOWN—The VC is not ready to carry traffic between the two VC endpoints.
•
Use the detail keyword to determine the reason that the VC is down.
ADMIN DOWN—The VC has been disabled by a user.
•
RECOVERING—The VC is recovering from a stateful switchover.
•
receive 0, send 0
receive 0, send 0
describes the significant fields shown in the display.
show mpls l2transport vc Field Descriptions
Description
Status of the line protocol on the edge-facing interface.
address as part of the mpls l2transport route command.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
show mpls l2transport vc
A-97
Hide quick links:
Advertisement
Table of Contents
