Configuring Inverse Multiplexing Over Atm (Ima) - Cisco 3825 Software Configuration Manual
Mobile wireless edge router
Hide thumbs
Also See for 3825:
- Non proprietary security policy (30 pages) ,
- Installation and upgrades (20 pages) ,
- Quick start manual (138 pages)
Table of Contents
Advertisement
Chapter 4
Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
For example, the following command specifies a recipient of the SNMP operation with a host-address
of 10.20.30.40 with a version SNMP of SNMPv2C:
Router(config)# snmp-server host 10.20.30.40 version 2c
Exit the global configuration mode.
Step 7
Router(config)# exit
Configuring Inverse Multiplexing over ATM (IMA)
A new feature, Inverse Multiplexing over ATM (IMA) interface as a shorthaul has been implemented in
Cisco IOS Release 12.4(4)MR. With this feature, you can now configure existing UMTS commands on
IMA interfaces. No new commands are added for this new feature. Only previously existing Cisco IOS
commands have been added for this feature (see
RAN-O Command Reference"
Inverse multiplexing provides the capability to transmit and receive a single high-speed data stream over
multiple slower-speed physical links. In inverse multiplexing over ATM (IMA), the originating stream
of ATM cells is divided so that complete ATM cells are transmitted in round-robin order across the set
of ATM links. IMA is supported on the Cisco 2-port T1/E1-RAN card on the Cisco 3825 router.
OL-15667-03
–
ipmulticast—Enable SNMP ipmulticast traps.
ipran—Enable IP-RAN Backhaul traps.
–
ipsla—Enable SNMP IP SLA traps.
–
isdn—Enable SNMP isdn traps.
–
12tun—Enable SNMP L2 tunnel protocol traps.
–
mpls—Enable SNMP MPLS traps.
–
msdp—Enable SNMP MSDP traps.
–
mvpn—Enable Multicast Virtual Private Networks traps.
–
ospf—Enable OSPF traps.
–
pim—Enable SNMP PIM traps.
–
–
pppoe—Enable SNMP pppoe traps.
–
pw—Enable SNMP PW traps.
rsvp—Enable RSVP flow change traps.
–
snmp—Enable SNMP traps.
–
srst—Enable SNMP srst traps.
–
syslog—Enable SNMP syslog traps.
–
tty—Enable TCP connection traps.
–
voice—Enable SNMP voice traps.
–
vrrp—Enable SNMP vrrp traps.
–
vtp—Enable SNMP VTP traps.
–
xgcp—Enable XGCP protocol traps.
–
for detailed command information).
Appendix A, "Cisco 3825 Mobile Wireless Edge Router
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
Configuration Sequence
4-37
Hide quick links:
Advertisement
Table of Contents
