Table of Contents
Advertisement
• Multiplication
• Pairing
• Modulation
• Spring
• Spiral
This section describes the menu for setting modifiers for
the main pattern as an example.
Setting the wipe direction (Direction)
Set the direction of travel of the wipe.
Normal
Wipe in the normal direction.
Reverse
Wipe in the opposite direction of the normal direction.
Normal/Reverse
Alternate directions between normal and reverse after each
transition.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
In the [Direction] group, select a wipe direction.
To set the wipe direction using buttons in the
transition control block
You can set the wipe direction using the transition control
block of the target switcher bank.
Note
The buttons used for configuring the wipe direction must
be assigned to the transition settings section of the
transition control block beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
Press one of the following wipe direction selection
buttons.
[NORM] button: Normal
[NORM/REV] button: Normal/Reverse
[REV] button: Reverse
Splitting a wipe pattern (Split)
You can split a wipe pattern, making the parts of the wipe
move in opposite directions.
Split disabled
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Pattern Mix/Edge/Direction menu (11109.33).
2
Set the [Split] button to the on state and set the
following parameters.
No.
Parameter
1
Split No.
2
Spacing
Modifying a wipe pattern edge (Edge)
Border
Adds a border to a pattern.
Soft
Softens the edges of a pattern.
Soft Border
Softens a border applied to a pattern.
When a border or soft border is selected, select a signal to
insert (edge fill) in the border.
102
Split enabled
Adjustment
Number of splits (1 to 4)
Spacing between adjacent
patterns
- Quick Links:
- Control Panel Configuration
Hide quick links:
Advertisement
Table of Contents
