1
Open the Home > Setup > Switcher > Custom >
Transition menu (19103.41).
2
Select the target switcher bank to set.
3
Enable/disable using the [Bus Toggle] switch.
On: Flip-flop mode
Off: Bus fixed mode
Setting the Preset Color Mix Mode
1
Open the Home > Setup > Switcher > Custom > Preset
Color Mix menu (19103.42).
2
Select the target switcher bank to set.
3
Press the [Stroke Mode] button and select a stroke
mode from the pull-down list.
Normal: Normal mode
Execute a preset color mix with two transition
operations.
Single: Single mode
Execute a preset color mix with one transition
operation.
Note
In bus fixed mode, single mode (fixed) is selected.
4
Press the [Edit] button for [Non Drop Key].
The [Set Non Drop Key] window appears.
5
Place a check mark in the keys to keep their insertion
status.
You can select multiple keys.
6
Press [OK].
7
Enable/disable one-time mode using the [One Time
Enable] switch.
On: Return to previous transition type after a
transition ends.
Off: Maintain a preset color mix after a transition
ends.
Enabling/Disabling Fade-To-Black
You can enable/disable fade-to-black for each program
output (PGM1 to PGM4).
1
Open the Home > Setup > Switcher > Custom >
Transition menu (19103.41).
2
In the [FTB] group, select the program outputs (PGM1
to PGM4) to enable.
Note
When the switcher bank operation mode is standard
mode, the [PGM2] to [PGM4] buttons cannot be
selected.
Setting the DME Wipe Edge
Softness Function
You can display the input image so that it fills the frame
when executing a DME wipe by disabling the edge
softness function.
Disabling will disable the edge softness function in any of
the following cases.
• When [Crop] is disabled in the [Crop Mode] group in the
Bus/Transition > DME Wipe > Modify menu of a
switcher bank
• When [Crop] is enabled in the [Crop Mode] group in the
Bus/Transition > DME Wipe > Modify menu of a
switcher bank and the [Top] and [Right] parameters are
set to "100.00" and the [Left] and [Bottom] parameters
are set to "–100.00"
• When the DME wipe direction is reverse and before
execution of a transition
1
Open the Home > Setup > Switcher > Custom >
Transition menu (19103.41).
2
Enable/disable using the [Full Size Edge Soft] button.
On: Enable the edge softness function.
Off: Disable the edge softness function.
Setting the Fader Lever Operation
Mode
You can set the relationship between the fader lever
position and the progress state of a transition.
1
Open the Home > Setup > Switcher > Custom >
Transition menu (19103.41).
2
In the [Fader Curve] group, select a fader lever
operation mode.
Normal: The transition progresses according to the
fader lever position.
A tally is output at the same time the transition
starts.
Adv Tally Mode: When the fader lever is moved from
the end of its travel, a tally is output before the
312