first event when the macro is recalled by any
method other than a macro attachment.
Setting the operation of buttons when
configuring a macro attachment
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
In the [Attachment Setting Mode] group, select an
operation mode.
With Button Function: Simultaneously execute
button function.
W/o Button Function: Do not execute button
function.
Setting the macro attachment enable/
disable configuration mode
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
In the [Macro Attach Enable Setting Mode] group,
select a configuration mode.
Manual: Enable/disable a macro attachment
manually. Enable/disable using the [MCRO
ATTCH ENBL] button in the cross-point control
block or a button assigned with the "Macro
Attachment Enable" utility command.
Enable: Always enable macro attachments.
Disable: Always disable macro attachments.
Lighting buttons configured with a macro
attachment
When macro attachments are enabled in the cross-point
control block, you can set to light the cross-point buttons
with a macro attachment in green.
Note
Buttons for selected cross-points do not light up green
even when a macro attachment has been configured.
1
Open the Home > Setup > Panel > Custom > Effect
TL/Macro Mode menu (19104.63).
2
Set the indication mode using the [Attchd Btn
Indication] button.
On: Cross-point buttons with a macro attachment are
lit green.
Off: Cross-point buttons with a macro attachment are
not lit.
Setting High Tally
You can select a tally to reflect in the control panel.
1
Open the Home > Setup > Panel > Custom > Button
Tally menu (19104.64).
2
In the [Tally Type] group, select a tally.
R1 to R8: Red tally in tally group 1 to 8
Independent: Tally generated by the switcher
To return to the previous setting
Press the [Clear] button.
3
Press the [Apply] button.
329