The [Assign V/K Pair] window appears.
5
Select a video signal or key signal in [Select Source
Type].
To select a video signal, set the [Video] radio button to
the on state.
To select a key signal, set the [Key] radio button to the
on state.
6
Set the button for the link destination V/K pair number
to the on state.
Select a tab to change the V/K pair number to display.
7
Press [OK].
To return a link table to the initial settings
Press the [Initialize Table] button, check the message, then
press [OK].
Setting an M/E Link
You can link the transition operations between switcher
banks.
The following operations are linked.
• Transition execution (auto transition, cut, and fader lever
operation)
• Next transition selection
• Transition type selection
1
Open the Home > Setup > Link > M/E Link menu
(19107.21).
2
Select the target link number to set.
To select and set multiple link numbers, place a check
mark beside the target link numbers to set.
To select and set all link numbers, place a check mark
in the Select All checkbox.
3
Enable/disable the link using the [Link Enable] switch.
On: Enable link.
Off: Disable link.
4
Press the [Controlling M/E] button and select a link
source switcher bank from the pull-down list.
5
Press the [Linked M/E] button and select a link
destination switcher bank from the pull-down list.
6
Select the operations to link using the [Transition
Only] switch.
On: Link transition execution only.
Off: Link transition execution, next transition
selection, and transition type selection.
347