Trackball (vertical rotation): Adjusts the border
width in the Y-axis direction (top/bottom edges)
Z-ring: Adjusts the border width simultaneously in
the X-axis and Y-axis directions
To finely adjust the setting values of parameters
Press the [FINE] button, turning it on.
The adjustment mode switches to fine mode, enabling
fine adjustment of setting values using the trackball/Z-
ring.
To restrict the parameters targeted by the
operation
Press the [X] button, [Y] button, or [Z] button, turning
it on.
This enables operation only for the selected axis using
the trackball/Z-ring.
Setting a Crop
Note
When a video signal and key signal are selected for resizer
mosaic/defocus, crop is disabled.
Setting a crop (menu)
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Adjust/DME Select menu (11101.41).
2
Set the [Resizer] button to the on state.
3
Set the [Crop] button to the on state and set the
following parameters.
No.
Parameter
1-1
H
1-2
V
1-3
All
2-1
Top
2-2
Left
2-3
Right
2-4
Bottom
a) The entered numeric value is automatically a positive value for the
right and top edges and a negative value for the left and bottom edges.
To soften the edges
Set the [Edge Soft] button to the on state and set the
following parameter.
Adjustment
Simultaneous adjustment of
a)
crop of left and right edges
Simultaneous adjustment of
crop of top and bottom edges
a)
Simultaneous adjustment of
crop of top, bottom, left, and
a)
right edges
Crop of top edge
Crop of left edge
Crop of right edge
Crop of bottom edge
No.
Parameter
1
Soft
Setting a crop (device control block)
When the crop setting is enabled in the menu, you can
adjust the crop of the top, bottom, left, and right edges
using the device control block.
Note
The buttons used for configuring a crop must be assigned
to the operation buttons of the device control block
beforehand.
For details about assigning buttons, see "Assigning
Control Panel Buttons" (page 317).
1
Press the [M/E 1] button.
2
Press the [K1RSZ] button.
3
Press the [RSZR ON] button, turning it on.
4
Press and hold the [SHIFT] button, and press the
[BDR/CROP] button, turning it on green.
5
Select the target edge to crop using the [X] button/[Y]
button/[Z] button/[CTR] button and adjust the crop
using the Z-ring.
[X] button: Adjustment of crop of top edge
[Y] button: Adjustment of crop of left edge
[Z] button: Adjustment of crop of right edge
[CTR] button: Adjustment of crop of bottom edge
If an edge to crop is not selected, operating the Z-ring
adjusts the crop width of all edges.
To finely adjust the setting values of parameters
Press the [FINE] button, turning it on.
The adjustment mode switches to fine mode, enabling
fine adjustment of setting values using the Z-ring.
Setting a CG Border
The resizers of two keys are used for CG border settings.
The combination of key pairs used is fixed (keys 1 and 2,
keys 3 and 4, keys 5 and 6, keys 7 and 8). The CG border
settings are configured for odd-numbered keys (1, 3, 5, 7).
This section describes setting a CG border using key 1 and
key 2 as an example.
Notes
• To change the position and size of the image embedded
in the border, clean mode must be enabled on the target
key. Enabling the CG border settings on key 1
92
Adjustment
Edge softness