Note
To configure a menu shortcut, the control panel must be
linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 43).
1
Open the Home > Setup > Panel > Module > Utility
Function Assign menu (19104.22).
2
Select the target bank to set in the utility control block/
cross-point control block.
For a utility control block
Press the [UTIL/SBOX] button to switch the memory
recall section to utility/shotbox operation mode and
select a bank (1 to 20) using the bank selection buttons.
For a cross-point control block
You can assign a utility/shotbox bank (1 to 10) to a
cross-point button row.
3
Set the [Menu Shortcut] button to the on state.
Buttons that can be assigned an action start flashing in
the utility control block/cross-point control block.
4
Display the target menu to register.
5
Press a button to assign an action from the buttons that
are flashing in the utility control block/cross-point
control block.
6
Set the [Menu Shortcut] button to the off state.
The setup operation ends and the buttons stop flashing.
To set a name
Press the [Name] button and enter a name (up to 8
characters) using the keyboard.
When multiple buttons are selected, consecutively
numbered names are set.
For details, see "Name settings when multiple items are
selected" (page 43).
To release the assignment
Select the target button to release and press the [Clear]
button.
Inhibiting DME Channel
Operations
You can inhibit DME channel selection operations in the
device control block.
1
Open the Home > Setup > Panel > Module > DME
Channel Inhibit menu (19104.23).
2
Select the target DME channel to set.
To select and set multiple DME channels, place a
check mark beside the target DME channels to set.
To select and set all DME channels, place a check
mark in the Select All checkbox.
3
Set the [Inhibit] switch to the on state.
319