hit counter script

Configuring Snmp V1 And Snmp V2C - Sony XVS-G1 User Manual

Multi format switcher system
Hide thumbs Also See for XVS-G1:
Table of Contents

Advertisement

5
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
6
Check the message, then press [OK].

Configuring SNMP v1 and SNMP v2c

You can configure a community and host when SNMP v1
or SNMP v2c is enabled.
Setting a community
Note
The following community names are set by default.
To prevent security risks, we recommend changing the
community names from the default values.
Read-Only Community: public
Read-Write Community: private
Trap Community: unknown
1
Open the System Configuration > SNMP > SNMP v1/
v2c > Community menu (20701.21).
2
Press the [Read-Only Community] button for
[Community Name] and enter an MIB read-only
community name (up to 255 characters) using the
keyboard.
3
Press the [Read-Write Community] button for
[Community Name] and enter an MIB read/write
community name (up to 255 characters) using the
keyboard.
4
Press the [Trap Community] button for [Community
Name] and enter a community name (up to 255
characters) to add when sending a trap using the
keyboard.
5
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
6
Check the message, then press [OK].
Configuring a host
1
Open the System Configuration > SNMP > SNMP v1/
v2c > Hosts menu (20701.22).
2
Press an [IP Address 1] to [IP Address 3] button for
[SNMP v1/v2c Communication Hosts] and enter an
SNMP manager allowed to connect using the
keyboard.
You can enter an IPv4 address, IPv6 address, or FQDN
(fully qualified domain name) for the SNMP manager,
or a network IPv4 address or IPv6 address.
3
Press an [IP Address 1] to [IP Address 3] button for
[SNMP v1/v2c Trap Hosts] and enter a destination
SNMP manager to send traps using the keyboard.
You can enter an IPv4 address, IPv6 address, or FQDN
(fully qualified domain name) for the SNMP manager.
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button, check the message, then press
[OK].
5
Check the message, then press [OK].
To send a test trap
Press the [Send Test Trap] button.
365

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF