Threading The Round-Sheath Ribbon Cable Into The Connector - Siemens SIMATIC S7-300 Reference Manual
Programmable logic controllers module data
Hide thumbs
Also See for SIMATIC S7-300:
- Manual (676 pages) ,
- Installation and operating manual (356 pages) ,
- Hardware and installation manual (256 pages)
Table of Contents
Advertisement
Cable end to ...
Cable end to ...
... top connector of front
connector module
... bottom connector of
front connector module
... top connector of front
connector module
... bottom connector of
front connector module
... socket of terminal
block
2. Thread the cable into the 16-pin connector.
It is important that you note the position of the details marked in the following
figure.
Figure 8-2
3. Clamp the end of the cable into the connector with the crimping tool.
4. Attach the strain relief device to the connector of the terminal block as follows:
– Fold back the cable over the connector
– Push the enclosed strain relief device over the cable
– Snap the strain relief device into place on the connector
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
SIMATIC TOP Connect and SIMATIC TOP Connect TPA
Cable sheath to
be removed
20-pin
front
connec-
tor
1 x 16 core
1 x 16 core
110 mm
shielded/uns
shielded/uns
hielded
70 mm
2 x 16 core
95 mm
unshielded
40 mm
Triangle
Nose
Threading the Round-Sheath Ribbon Cable into the Connector
external
internal
ribbon
ribbon
cable
cable
40-pin
front
20-pin
connec-
front connector
tor
115 mm
75 mm
95 mm
115 mm
40 mm
Marked Core
external
internal
ribbon
ribbon
cable
cable
40-pin
front connector
115 mm
75 mm
100 mm
8-5
- Quick Links:
- Controllers S7
- Siplus S7-300 Modules
Hide quick links:
Advertisement
Table of Contents
