Warnings - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Advertisement
Rexroth IndraDrive
Clearing Errors
Booting and Firmware Download
Warnings
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Diagnostic
Error class
message
number
F2xxx
non-fatal error
F3xxx
non-fatal safety
technology
error
F4xxx
interface error
F6xxx
travel range
error
F7xxx
safety
technology
error
F8xxx
fatal error
F9xxx and
fatal system
E-xxxx
error
Fig. 1-15:
Error classes and drive reaction
Errors are not automatically cleared; they have to be cleared by:
• the control unit by activating the S-0-0099, C0500 Reset class 1
diagnostics command or
• by the user via the control panel
Note:
Some errors can only be cleared in communication phase 2.
If the error status persists the drive controller generates the error
message again.
Errors
Note:
Apart from the mentioned error classes that can occur during
operation, errors can occur when the devices are booted and
during firmware download. These errors are not displayed at
the control panel with a diagnostic message number of the
"Fxxxx" pattern, but with a short text. Booting and firmware
download errors are described separately.
While in operation the drive controller carries out monitoring functions.
Some monitoring functions depend on the operating mode that is used
and/or parameter settings. If a status is detected that still allows correct
operation but persists, which would then cause an error to be generated,
a warning is generated.
Note:
Some warnings won't result in an error if they are ignored.
Basics on Device Diagnosis
Drive reaction
as set in P-0-0119, Best possible
deceleration
as set in P-0-0119, Best possible
deceleration
as set in P-0-0119, Best possible
deceleration
speed command value reset
Closed Loop: speed command value reset
Open Loop: deceleration under compliance
with P-0-0569, Maximum stator frequency
change
torque disable
torque disable
1-17
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Advertisement
Table of Contents
