Cisco ASR 1013 Hardware Installation Manual page 303

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1002 Router Overview and Installation

After the lead wire is fully inserted, hold the lead wire in place by pressing inward while you remove the screwdriver to

release the spring to tension down on the installed lead wire, then perform these steps:

a) Hold the lead wire in place while you are removing the screwdriver.

b) Once the screwdriver is completely removed, gently pull on the lead wire to make certain that the lead wire is securely

The following shows a lead wire fully inserted, and the screwdriver being removed while you gently pull on the lead

Figure 111: Removing a Screwdriver from the +24 VDC Power Supply Terminal Block

Repeat Steps 5 through Step 10 for each lead wire.

Gently pull on lead wire.

Cisco ASR 1000 Series Router Hardware Installation Guide

Connecting Cisco 24 VDC Power Supply

Show Quick Links

Table of Contents

Troubleshooting