Cisco ASR 1013 Hardware Installation Manual page 505

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1000 Series Routers Power Up and Initial Configuration

SUMMARY STEPS

1. Slip on the ESD-preventive wrist strap that was included in the accessory kit.

2. Enter the reload command.

3. Confirm the reload command.

4. After confirming the reload command, wait until the system bootstrap message displays before powering

off the system.

5. Remove any power cables from the Cisco ASR 1000 Series Router.

DETAILED STEPS

Slip on the ESD-preventive wrist strap that was included in the accessory kit.

Enter the reload command.

Confirm the reload command.

Router# reload

Proceed with reload? [confirm]

Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis

After confirming the reload command, wait until the system bootstrap message displays before powering off the system.

System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)

Technical Support: tap://www.cisco.com/techsupport

Current image running: Boot ROM0

Last reset cause: LocalSoft

ASR1000-RP1 platform with 4194303 Kbytes of main memory

mcp-6ru-1-rp0-rommon 1>

Remove any power cables from the Cisco ASR 1000 Series Router.

a) For power supplies with a circuit breaker switch, position the switch to the Off (O) position.

b) For power supplies with a Standby switch, place the Standby switch in the Standby position.

After powering off the router, wait a minimum of 30 seconds before powering it on again.

Powering Off the Cisco ASR 1000 Series Router Safely

Cisco ASR 1000 Series Router Hardware Installation Guide

Show Quick Links

Table of Contents

Troubleshooting