Cisco ASR 1013 Hardware Installation Manual page 304

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Connecting Cisco 24 VDC Power Supply

The following shows all the lead wires installed.

Figure 112: Cisco +24 VDC Power Supply Terminal Block With Lead Wires Installed

Make sure the stripped end of each lead wire is twisted tightly together. This makes insertion easier. Then make

certain the entire lead wire is inserted all the way into its receptacle. If any exposed wire at the stripped end of

a lead is visible after inserting the lead into its receptacle, remove the lead from the receptacle, use the wire

stripper to cut the stripped end of the lead, and then reinsert.

When securing the ground, positive, and negative +24 VDC-input leads to the power supply faceplate, leave

extra service loop in the ground (GND) lead to ensure that the ground lead is the last lead wire to disconnect

from the power supply if a great deal of strain is placed on all three leads.

Cisco ASR 1000 Series Router Hardware Installation Guide

Positive lead wire

Negative lead wire

Cisco ASR 1002 Router Overview and Installation

Ground lead wire

Show Quick Links

Table of Contents

Troubleshooting