Cisco ASR 1013 Hardware Installation Manual page 490

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Installing DC Input Power on the Cisco ASR 1001 Router

The following figure shows the DC power supply with lead wires.

Figure 223: DC Power Supply with Lead Wires

Insert the exposed wire of one of the ground wire into the terminal block plug. Ensure that you cannot see any wire lead.

Only wires with insulation should extend from the terminal block.

Do not overtorque the terminal block plug captive screws. The recommended maximum torque is from 0.5

Nm (4.425 lbf in.) to 0.6 Nm (5.310 lbf in.).

Cisco ASR 1000 Series Router Hardware Installation Guide

Negative (–) lead wire

Positive (+) lead wire

Cisco ASR 1001 Router Overview and Installation

Ground lead wire

Show Quick Links

Table of Contents

Troubleshooting