Cisco ASR 1013 Hardware Installation Manual page 381

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1002-X Router Overview and Installation

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the

absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority

or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Before you connect power or turn on power to your chassis, you must provide an adequate chassis ground

(earth) connection for the chassis. The chassis ground lug (two) and the respective screws (four) are provided

in the accessory kit that shipped with your Cisco ASR 1002-X Router.

The grounding wire is always the first to be installed or connected and the last to be removed or

disconnected.

The following tools, equipment, and supplies are necessary to connect the system ground to the chassis:

hillips screwdriver

• Dual-lug chassis ground component (two) and respective screws (four) (shipped with the accessory kit)

• Grounding wire

The following image shows the location of the ground lug on the side of Cisco ASR 1002-X Router.

Figure 159: Cisco ASR 1002-X Router Chassis Ground Lug Location

To attach the grounding lug to the chassis ground connector on your chassis, follow these steps:

Cisco ASR 1002-X

Router ground stud

Cisco ASR 1000 Series Router Hardware Installation Guide

Attaching a Chassis Ground Connection

Show Quick Links

Table of Contents

Troubleshooting