Cisco ASR 1013 Hardware Installation Manual page 481

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1001 Router Overview and Installation

The following image shows the Cisco ASR 1001 Router AC power supplies.

Figure 215: Cisco ASR 1001 Router AC Power Supplies

Follow these steps to connect an AC input power supply to the Cisco ASR 1001 Router.

SUMMARY STEPS

1. There are two power supplies installed. At the rear of the chassis, check that the power switch on the

chassis is in the standby position.

2. Turn off the circuit breaker to the power supply.

3. For easier installation, plug the power cable into the inlet on power supply slot 1 first.

4. Then insert the power supply cable into the power supply in slot 0 on the right.

5. Make certain that the AC power cords are positioned as shown in the following image.

6. Plug the AC power supply cables into the AC power source.

7. Turn on the AC breaker.

8. Turn the Standby switch to On (|) on the chassis.

9. The power supply LED illuminates green.

DETAILED STEPS

There are two power supplies installed. At the rear of the chassis, check that the power switch on the chassis is in the

standby position.

Installing AC Input Power to Cisco ASR 1001 Router

Cisco ASR 1000 Series Router Hardware Installation Guide

Show Quick Links

Table of Contents

Troubleshooting