Cisco ASR 1013 Hardware Installation Manual page 338

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Attaching a Chassis Ground Connection

Use the manufacturers's recommended crimping tool to carefully crimp the wire receptacle around the wire; this step is

required to ensure a proper mechanical connection.

Locate the chassis ground connector on the side of your chassis as shown in the following imave.

Insert the two screws through the holes in the grounding lug as shown in

Chassis Ground Connector, on page

Figure 134: Attaching a Grounding Lug to the Chassis Ground Connector

Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the chassis.

Do not overtighten the screws.

Connect the opposite end of the ground wire to the appropriate grounding point at your site to ensure an adequate chassis

What to Do Next

This completes the procedure for attaching a chassis ground connection. Go to the following cabling sections

for information on attaching cables.

Cisco ASR 1000 Series Router Hardware Installation Guide

Chassis ground connector

Cisco ASR 1002-F Router Overview and Installation

Figure 134: Attaching a Grounding Lug to the

Ground symbol

Show Quick Links

Table of Contents

Troubleshooting