Cisco ASR 1013 Hardware Installation Manual page 588

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing a DC Power Supply in Cisco ASR 1006 Router

The following figure shows the terminal block ground lugs for the ASR1013/06-PWR-DC power supply of the Cisco

ASR 1006 Router.

Figure 272: Cisco ASR 1006 Router DC Power Supply (ASR1013/06-PWR-DC) Ground Lug Installation

For easier cable-management, insert the positive cable first. Replace the ground lug with cable in the following order:

a) Flat Washer

b) Ground lug with positive wire

c) Kepnut screw

Tighten the Kepnut screw (use the screwdriver to tighten the ground screw in the terminal block to a torque of 20+/–2

in-lbs / 2 per.) and repeat the same steps for the negative wires.

Secure the wires coming in from the terminal block so that they cannot be disturbed by casual contact.

Use tie wraps to secure the wires, so that the wires are not pulled from the terminal block by casual contact. Ti-wrap

studs are located below the power supply terminal block.

The ground wire must contain a loop when securing it to the tie-wrap tab to prevent it from being pulled

Cisco ASR 1000 Series Router Hardware Installation Guide

DC power supply grounding

stud with wire

Grounding screws

DC power supply ground

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Kepnut screw

Show Quick Links

Table of Contents

Troubleshooting